How To - learning new techniques

From LogiWiki
Revision as of 16:27, 25 August 2020 by Joesipaq (talk | contribs)
Jump to navigation Jump to search

Hello all! So there have been a few times when someone knows what they want to do, but may be lacking the abilities or knowledge on how to do it.
I thought it would be a good idea to create a new page for this - Mostly I have a feeling that there will be linking to some videos. If a picture is worth 1000 words, what is 30fps worth?

Warping stencil trick

First up on the list is something I personally do when reballing larger BGA - This one is of an iPhone 7 CPU. If you get the techniques used here, SMC is NO PROBLEMO.


Check out at 49:15

Direct Link to the time stamp [1]

The important things to note are - I am applying pressure in the centerish of the stencil. Not worried about the solder paste below the tweezers as it will flow. But this will stop your stencil from bowing/lifting in the center. I like to use 385c by 40 air on my Quick. Find a setting that works for you. This is what I like. It is not a rule or a solution.

Dried up solder paste

2nd up... Is your solder paste too dry or wet? Here is me being an foolish man, and refreshing my solder paste. It dried out to a clump and well, its what I had near by. Is your paste too dry or wet? This is what I do to thin out my paste some.


Check out at 1:02

Direct Link to the time stamp [2]

If you want it to be thicker. I will drag it across my black mat a few times to let the flux stick to the mat, but take the balls with my scraper. I don't use paper towel or stuff like that.

SMC Reballing

3rd up, is how I reball SMCs. The Quick and dirty way. This is the rest of that above video.


Check out at 12:03

Direct Link to the time stamp[3] I adopted this method after reballing about 50 macbook air RAM ICs from some other experiments. As the key to everything - Practice makes better.

iMac screen removal (2012 and newer)

4th up. Proper iMac screen removal practices. A huge pet-peeve I have is when I see an iMac screen cracked, the paint scratched from a razor blade or damage caused by heat - all due to another "professional" removing the screen. This is the right way to remove an iMac screen. Only addition that could be added is the "wedge" to hold the iMac angle and do this vertically. I like to do it laying down as in the video.


You will receive iMacs that have the wrong adhesive on them... I am sorry. Your life just became complicated. We charge quite a bit extra if we receive one of these. There is a lot higher risk that the screen will break, and to clean the screen and housing for the proper adhesive can take hours if you are aiming to have a flawless job.
Just take it slow, if opening it feels like there is something catching, STOP and study what is going on with that screen. One I had the other week - had B7000 all around it. I used a discarded plastic (the cover for the sticky side) from the a used seal to slip in at the bottom edge and slowly sliced through the B7000 silicone to free it from the housing at the end.